Skip to main content
Net zero & ESG consultants · Worcester, operating UK‑wide 01905 935 016 · info@gogreenexperts.co.uk
Book your free workshop
  1. Home
  2. Knowledge Base
  3. How it is calculated

How is a carbon footprint calculated?

The arithmetic is simple. Getting the inputs right, and being able to show your working two years later, is the job.

Method · about 6 minutes Last reviewed November 2026

The short answer

Every line of a carbon footprint is activity data × emission factor = emissions. Activity data is what you did — kilowatt hours consumed, litres of diesel, miles flown, pounds spent. The emission factor converts that into kilograms of CO2e. The inventory is the sum of those lines, built to the GHG Protocol, with a stated boundary, a stated year and a record of where each number came from.

The five steps

1. Set the boundary and the base year

Which entities, which sites, which twelve months. Pick a year you have decent data for rather than the most recent one, because the base year is what every future reduction is measured against and re-stating it later is painful.

2. Collect activity data

In rough order of how easily it comes to hand:

  • Metered energy — electricity and gas consumption in kWh, from bills or half-hourly data. Not the cost; the consumption.
  • Fuel — litres from fuel cards, or mileage plus vehicle type where litres are not available.
  • Refrigerants — top-up quantities and gas type from F-gas service records.
  • Travel — flight segments with origin, destination and cabin class; rail and hotel nights from the booking tool or the expense system.
  • Waste and water — tonnages and treatment route from the waste contractor.
  • Procurement — spend by supplier and category from the purchase ledger, which is the usual starting point for Scope 3 category 1.

3. Apply emission factors

UK reporting normally uses the Government's annual conversion factors for company reporting, published by DESNZ, with DEFRA factors for waste and sector-average or supplier-specific factors for purchased goods. The factor set has a year attached and it changes annually, so an inventory must record which vintage it used.

4. Convert to CO2e and aggregate

Each gas is multiplied by its global warming potential and the results summed into one figure per scope, per category and per site. Anything estimated is flagged as estimated.

5. Document the assumptions

This is the step that gets skipped and the step that gets audited. Every extrapolation, every proxy, every category judged immaterial needs a line explaining the reasoning. An inventory without that record is not wrong — it is simply unusable the moment anyone challenges it.

Where the numbers come from when you do not have them

No organisation has complete data in year one. Accepted practice is to estimate, and to say so:

  • Extrapolation — nine months of meter data scaled to twelve, noted as such.
  • Proxy data — a site with no sub-meter estimated from floor area and a benchmark intensity.
  • Spend-based factors — procurement spend multiplied by a sector-average factor per pound.
  • Supplier data — the better answer for your top suppliers, and the thing to work towards.

The quality of an inventory is not whether it contains estimates. It is whether the estimates are declared, consistent between years, and replaced with measured data over time.

What an assessor or a customer will ask for

  • The standard used, and the consolidation approach
  • The reporting period and the base year
  • The emission factor set and its publication year
  • Scope 2 reported both location-based and market-based
  • Which Scope 3 categories are included, and the stated reason for any excluded
  • An intensity ratio — tonnes per employee, per £m turnover, or per unit of output — because absolute figures alone do not survive a change in headcount

Spreadsheet or software?

A single-site organisation under a hundred people can be modelled perfectly well in a spreadsheet, and often should be. Multi-site, multi-entity or annually assured reporting outgrows that quickly, less because of the arithmetic than because of version control and the audit trail.

We build in whichever the organisation can maintain after we leave. An elegant model nobody internally can update is worth less than a plain one somebody owns.

What this means for your organisation

Before calculating anything, find out which obligation is driving the request — it sets the boundary, the year and the assurance level, and those are expensive to change afterwards.

Three questions will tell you which regimes apply, and the free workshop covers the data-gathering list in person.

Every inventory we have built since 2013 was built this way.

1.5 million tonnes of CO2e measured across client inventories, every one of them to the GHG Protocol, with the assumptions written down.